[Options] - NEC NP3150 User Manual

[OPTIONS]

Setting Auto Adjust [AUTO ADJUST]
OFF ........................ The RGB image will not be automatically adjusted.
You can manually optimize the RGB image.
NORMAL ................ Default setting. The RGB image will be automatically adjusted. Normally select this option.
FINE ....................... Select this option if fine adjustment is needed. It takes more time to switch to the source than when
[NORMAL] is selected.
Enabling Auto Start [AUTO START]
Enabling Power Management [POWER MANAGEMENT]
W
Enabling High Speed Fan Mode [FAN MODE]
AUTO ..................... The built-in fans automatically run at a variable speed according to the internal temperature.
HIGH ...................... The built-in fans run at high speed.
HIGH ALTITUDE ..... The built-in fans run at a high speed. Select this option when using the projector at altitudes approximate-
ly 5500 feet/1600 meters or higher.
W
NOTE:
• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.
• Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE] can cause
the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
• Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE] can cause the
lamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].
• Your setting will not be affected even when [RESET] is done from the menu.
R
OR
POWER O
115
6. Using On-Screen Menu
E
O