GE MI-869 Instruction Manual page 478

FLEXLOGIC
4–360
The following cases depict the nature of the three time stamps after a file conversion.
Source Version Target
Version
>= 160 >= 160
>= 160 >=160
< 160 >= 160
< 160 (& > 120***) >= 160
** LDLs – Logic Designer Last Saved,
LDLc– Logic Designer Last Compiled and
FELs – FlexLogic Editor Last Saved
** PCTime The time that the file conversion took place
^ 0 Indicates the time stamps are being defaulted
*** There is no support for Logic Designer [Graphical Editor] below version 130
* For each specific case, the source files for Logic Designer (Graphical) content will
also get copied "as is" to the destination folder. This enables the user to retain old
content "as is".
In a typical scenario where both the FlexLogic Designer and FlexLogic Editor are used for
configuring FlexLogic, the updated time stamps will appear as shown in the following
figure.
Logic Designer: This entry can be used to initiate the launch of the 'Logic Designer' screen.
Once chosen, the existing 'FlexLogic Equation Editor' screen is set to Read-only and then
the 'Logic Designer' screen launch is initiated.If the user wants to re-visit the FlexLogic
Editor Screen, any existing read-only screen has to be closed first. Then, the screen has to
be re-opened. The FlexLogic Editor screen is now editable, again.
In order to maintain synchronization of FlexLogic, the following update rules are defined.
For example, when a user tries to open the 'FlexLogic Equation Editor' of a particular
device or file.
• If the 'Logic Designer' screen is open and in Edit mode, a message prompts the user to
save any changes. The 'FlexLogic Equation Editor' is not launched.
• If the 'Logic Designer' is open and in saved mode (no edits to save or compile), the
'Logic Designer' screen is closed and then the 'FlexLogic Equation Editor' launch is
initiated.
Is FlexLogic Time Stamps
Change Detected? [LDLs, LDLc, FELs]**
YES [ 0^ , 0 , PCTime**]
NO *Existing time stamps are copied to
the converted file
YES [ 0 , 0 , PCTime]
NO [PCTime, PCTime, PCTime,]
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: SETPOINTS