Stanley SCH12 Original Instructions Manual page 8

ENGLISH
(Original instructions)
Discard the battery pack with due care for the environment.
Charge STANLEY battery packs only with designated
STANLEY chargers. Charging battery packs other than
SC121
the designated STANLEY batteries with a STANLEY
charger may make them burst or lead to other dangerous
situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Hammer drill
1 Charger
2 Batteries (S2) or 1 Battery (S1)
1 Instruction manual
NOTE: Battery packs and chargers are not included with
N-models.
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
FEATURES (Fig. A)
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjustment Collar
4. Gear shifter
5. Keyless Chuck
6. Battery Release Button
7. Battery pack
8. LED Work Light
9. Function collar
INTENDED USE
This hammer drill is designed for light fastening and drilling
applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
This hammer drill is a professional power tool.
DO NOT let children come into contact with the tool. Supervision
is required when inexperienced operators use this tool.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or mental
abilities, or for lack of experience and/or for want of knowledge
or skills unless they are supervised by a person responsible for
their safety. Children should never be left alone to play with this
product.
8
Electrical Safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Your STANLEY charger is double insulated in accordance with
EN 60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY service
organization.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for the
power input of your charger (see Technical Data). The minimum
conductor size is 1 mm2; the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
Assembly and adjustments
WARNING: Prior to assembly and adjustment, always
remove the battery pack. Always switch off the tool
before inserting or removing the battery pack.
WARNING: Use only STANLEY battery packs and
chargers.
Inserting and Removing the Battery Pack from the Tool (fig. C)
WARNING: To reduce the risk of serious personal
injury, place the forward/reverse button in the lock-
off position or turn tool off and disconnect battery
pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can
cause injury.
NOTE: Make sure your battery pack (7) is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (6) and firmly pull the battery pack out
of the tool handle.
2. Insert battery pack into the charger as described in the charger
section of this manual.
OPERATING INSTRUCTIONS
Safety warnings and instructions: Drills
WARNING: Always observe the safety instructions and
applicable regulations.
WARNING: To reduce the risk of serious personal
injury, place the forward/reverse button in the lock-
off position or turn tool off and disconnect battery pack