Accessories & Prepare On Site - Mitsubishi RC-EX3 Installation Manual

● When installing the unit at a hospital, telecommunication facility, etc., take measures to
suppress electric noises.
It could cause malfunction or break-down due to hazardous effects on the inverter, private power generator, high frequency
medical equipment, radio communication equipment, etc.
The influences transmitted from the remote control to medical or communication equipment could disrupt medical activities,
video broadcasting or cause noise interference.
● Do not leave the remote control with its upper case removed.
If dew, water, insect, etc. enters through the hole, it could cause electric shocks, fire or break-down.
● Do not install the remote control at following places.
(1) It could cause break-down or deformation of remote control.
・Where it is exposed to direct sunlight
・Where the ambient temperature becomes 0 °C or below, or 40 °C or above
・Where the surface is not flat
・Where the strength of installation area is insufficient
(2) Moisture may be attached to internal parts of the remote controller, resulting in a display failure.
・Place with high humidity where condensation occurs on the remote controller
・Where the remote controller gets wet
(3) Accurate room temperature may not be detected using the temperature sensor of the remote controller.
・Where the average room temperature cannot be detected
・Place near the equipment to generate heat
・Place affected by outside air in opening/closing the door
・Place exposed to direct sunlight or wind from air conditioner
・Where the difference between wall and room temperature is large
● To connect to a personal computer via USB, use the dedicated software.
Do not connect other USB devices and the remote controller at the same time.
It could cause malfunction or break-down of the remote controller/personal computer.
2 . Accessories & Prepare on site
Following parts are provided.
Accessories R/C main unit, wood screw (ø3.5 x 16) 2 pcs, Quick reference
Following parts are arranged at site. Prepare them according to the respective installation procedures.
Item name
Switch box
For 1 piece or 2 pieces (JIS C8340 or
equivalent)
Thin wall steel pipe for electric
appliance directly on a wall.
(JIS C8305 or equivalent)
Lock nut, bushing (JIS C8330 or equivalent)
Lacing (JIS C8425 or equivalent)
Putty
Molly anchor
R/C cable (0.3 mm 2 x 2 pcs)
WA R N I N G
C A U T I O N
Q'ty Remark
1
These are not required when
installing directly on a wall.
As required
As required
Necessary to run R/C cable on
As required
the wall.
Suitably For sealing gaps
As required
See right table when longer than
As required
100 m
−5−
When the cable length is longer than
100 m, the max size for wires used
in the R/C case is 0.5 mm 2 . Connect
them to wires of larger size near
the outside of R/C. When wires are
connected, take measures to prevent
water, etc. from entering inside.
≦ 200 m
0.5 mm 2 x 2-core
≦ 300m 2
0.75 mm x 2-core
≦ 400m
1.25 mm 2 x 2-core
≦ 600m 2
2.0 mm x 2-core