Iu Overload Alarm; External Output Setting - Mitsubishi RC-EX3 Installation Manual

 IU overload alarm

IU overload alarm
IU overload alarm
キャンセル Cancel
Tap ▲▼ to set temp & tap [Set].
When the room temperature differs to
some extent from the setting temperature
at 30 minutes after the start of operation,
the overload alarm signal is transmitted
from the external output (CNT-5).
 External output function #2
External output function
Fan operation output 1
Fan operation output 2
Fan operation output 3
Defrost/oil return output
Ventilation output
前ペー ジ Previous 次ペー ジ Next
 External output function
External output function
External output 1
External output 2
External output 3
Set Set
External output 4
Back Back
Select the item.
Select the output destination to change and then select the function to be allocated to the
selected output.
The following shows output connectors and defaults.
External output 1
External output 2
External output 3
External output 4
Refer to the engineering data for details.
 External output function #3
External output function
Heater output
Free cooling output
Indoor unit overload alarm output
Back 前ペー ジ Previous
Back
Ｃ Ｎ Ｔ-2 Operation output
Ｃ Ｎ Ｔ-3 Heating output
Ｃ Ｎ Ｔ-4 Compressor ON output
Ｃ Ｎ Ｔ-5 Inspection (Error) output
Back
−28−
 External output function #1
External output function
Operation output
Heating output
Compressor ON output
Inspection (Error) output
Cooling output
次ペー ジ
Next Back