Installation Place; Installation Procedure - Mitsubishi RC-EX3 Installation Manual

3. Installation place

Secure the installation space shown in the figure.
For the installation method, "embedding wiring" or "exposing
wiring" can be selected.
For the wiring direction, "Backward", "Upper center" or "Upper left"
can be selected.
Determine the installation place in consideration of the installation
method and wiring direction.

4. Installation procedure

Perform installation and wiring work for the remote controller according to the
following procedure.
Dimensions (Viewed from front)
固定穴
Fixing holes
37
37
To remove the upper case from the bottom cases of R/C
· Insert the tip of flat head screwdriver or the like in the recess at the lower part of
R/C and twist it lightly to remove. It is recommended that the tip of the screwdriver
be wrapped with tape to avoid damaging the case.
Take care to protect the removed upper case from moisture or dust.
In case of embedding wiring
(When the wiring is retrieved "Backward")
① Embed the switch box and the R/C wires beforehand.
Seal the inlet hole for the R/C wiring with putty.
23 23
23 23
120
120
Installation space
Wiring
配線
30mm
30mm
R/C temperature sensor
Secure minimum spaces for disassembling the case.
Upper left and Upper right sides
......30mm or more
Bottom side...120mm or more
If using L-shaped screwdriver, 50mm or more is
available.
PCB side (Viewed from rear)
センサー
Sensor
19
19
Bushing
ブッ シ ング
50
8
−6−
下ケース配線穴
30mm 30mm
30mm
30mm
端子
USB
USB port Terminal block
Conduit
電線管
Wall
壁
Locknut
ロ ッ クナッ ト
Switch
スイ ッ チ
box
ボ ッ クス
パテで シール
Seal with putty
する こ と
200
R/C cable
リ モコ ン配線