Special Settings; Indoor Unit Capacity Display - Mitsubishi RC-EX3 Installation Manual

 Special settings

Special settings
Erase IU address
CPU reset
Restore of default setting
Touch panel calibration
30
Select the item.
The selected screen is displayed.
 Touch panel calibration ＃1
Tap [+] on the lower right.
Use this when the display and the touch position are not matched.
Tap the center of [+] and check the deviation from the display.
Finish ⇒ Calibration is completed.

 Indoor unit capacity display

Indoor unit capacity display
IU address Capacity
Next
Capacities of IUs connected to the R/C are
displayed.
When seven units or more are connected,
tap the Next button to view all.
These items may not be displayed
depending on the combination of IUs and
OUs.
Erase IU address
address for multi (KX) unit is erased.
CPU reset Microcomputers of IU and
OU connected are reset (State of restoration
after power failure).
Restore of default setting
R/C and IU connected are initialized (State of
factory default).
Back
Touch panel calibration
to correct when the display and the touch
position are not matched.
 Touch panel calibration ＃2
Tap [+] on the upper left.
Back
Memory of the IU
Settings on
Use this
−32−
 Touch panel calibration
Touch panel calibration
Start
If Yes, tap [Start].
 Touch panel calibration ＃3
Tap center of [+] & check screen position.
Cancel Redo Finish
Back