Monitoring; Cleaning The 920M Plus Pulse Oximeter - Respironics 920M PLUS Operator's Manual

Monitoring

Verify that the pulse oximeter sensor is properly positioned (on a finger, for
example). Ensure that the pulse oximeter is sensing adequate pulse quality by:
•
verifying that the pulse quality indicator is blinking green and
•
verifying that the pulse rate and SpO
•
verifying that the pulse quality indicator blinking is correlated to the pulse rate
for at least 10 seconds
If the pulse quality indicator light is blinking red or yellow or is blinking
erratically, reposition the pulse oximeter sensor or try a different sensor.
If a finger, toe, etc., is not properly inserted into the pulse oximeter sensor, or
no pulse oximeter sensor is attached to the pulse oximeter after startup (a few
seconds after powering on), both the SpO
a single dash until a valid pulse signal is detected.

Cleaning the 920M PLUS Pulse Oximeter

Clean the 920M PLUS Pulse Oximeter separately from the sensors. For
instructions on cleaning pulse oximeter sensors, refer to the respective pulse
oximeter sensor package inserts.
Clean the 920M PLUS with a soft cloth dampened with isopropyl alcohol. Do
not pour or spray any liquids onto the 920M PLUS, and do not allow any liquid
to enter any openings in the device. Allow the 920M PLUS to dry thoroughly
before reusing.
CAUTION: Do not immerse the 920M PLUS in liquid, and do not
use caustic or abrasive cleaning agents on the 920M PLUS.
10
displays are showing readings and
2
and pulse rate displays will display
2
Basic Operation