Rear Tail Light Bulb Replacement; Replacing The Number Plate Lamp - Husqvarna TE 310-450-510 210 I.E. Owner's Manual

REAR TAIL LIGHT BULB REPLACEMENT

(TE- SMR)
Remove the two fastening screws (1) in the inner side of the
rear fender and the lens (2).
Pull the lamp (3) inside, turn it counterclockwise then remove
it from the lamp holder.
After replacement, reverse operations for reassembly.
NOTES: make sure not to tighten the screws
excessively.

REPLACING THE NUMBER PLATE LAMP

(TE- SMR)
Pull out the number plate lampholder (4) from the back of the
vehicle. Pull out the lampholder and the bulb. Rotate the bulb
(5) to remove from the lampholder.
Once the bulb has been replaced, reverse the above procedure.
4
5
81