GRAUPNER 23608 Installation And User Manual page 18

14. The satellite receiver has now been programmed to communicate with the
Graupner IFS receiver.
15. If you have other satellite receivers or telemetry sensors attached, press and
release the programming button on each device, one at a time.
16. Disconnect power to the Graupner IFS receiver.
power of the satellite receiver(s).
2.2. Binding the satellite receiver
Now, that the telemetry communication
to the transmitter. You must bind your main Graupner IFS receiver and any satellite receivers
together.
1. Power the receiver (and any satellite receivers).
2. You must put the satellite receiver(s) into
IFS receiver. This is done by pressing and holding the programming button on the
satellite receiver until the STATUS LED turns green.
Bedienungsanleitung XZ-R1 IFS
has been completed, you must bind the satellite receiver
binding mode
Seite 18
This should also disconnect
before the main Graupner
Ver. 1.0