Table of Contents
Advertisement
Available languages
Available languages
Dust extractor port
1. Attach the dust extractor port to the footplate bracket as shown in the figure.
2. Connect the hose of the vacuum cleaner (industrial vac, ash cleaner or dust
extractor) to the dust extractor port.
Cut line blower
The saw has a blower function which keeps the cut line free of dust. The aperture is
located just behind the blade guide. Make sure that this aperture is kept free of debris
to ensure optimum blower performance.
LED work light
The saw has an LED work light (14) to help in poor lighting conditions. The light should
be kept clean to ensure optimum effect.
Operating instructions
Setting the speed
The stroke rate is controlled using the speed selector (15). Refer to the table below as
a guide.
•
Note: Do not run the saw for long periods at very low speed. Doing so can cause
the motor to overheat.
•
When you have used the saw at low speed and have finished work, let the motor
run at max speed under no load for a minute to cool it down.
Material
Speed setting
Wood
5–6
Metal
3–4
Aluminium
3–5
PVC
3–4
Ceramic
3–5
10
Advertisement
Table of Contents
