Pioneer KRP-500A Operating Instructions Manual page 51

Flat screen tv
Hide thumbs Also See for KRP-500A:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

Using with other equipment
Readable data files
This system can read only JPEG files that meet the following
conditions:
• Extensions are JPG or JPEG.
• JPEG 4:2:2 and 4:2:0 format
• The image resolution must be less than 3264 pixels in the
horizontal direction and 2448 pixels in the vertical direction.
• The image resolution must be higher than 160 pixels in the
horizontal direction and 120 pixels in the vertical direction.
Note
• This system may not be able to display images, depending on
the type of your memory card, or camera.
• This system may not be able to display images modified or
edited using a personal computer or other equipment.
• This system complies with the USB Mass Storage Class, SIC
(Still Image Capture) Class + PTP and Multiple LUN (Logical
Unit Number) Class.
Connecting a USB device
Hold the USB device's connector with its top side facing the front
panel, and then insert it into the USB port on the front panel of the
Media Receiver.
• Insert the USB device's connector as far as it goes.
• When using the USB connector of your device, connect it
directly to the USB port.
Media Receiver (front)
USB
INPUT 6
PHONES
VIDEO
ANALOG RGB
L AUDIO R
PC
USB flash drive, multi-card
reader or digital camera
Removing a USB device
To remove a USB device's connector, quit the Home Gallery screen
and then remove it.
Media Receiver (front)
USB
INPUT 6
PHONES
VIDEO
Note
• Be sure to quit the Home Gallery screen before removing the
USB device. If you remove the USB device while the Home
Gallery screen is displayed, data inside the memory may be
damaged.
• Do not insert or remove the USB device immediately after the
system is switched on or off. This may cause data inside the
memory to be damaged.
• Do not turn the digital camera off while the Home Gallery
screen is displayed.
Starting the initial Home Gallery screen
When you connect a USB device while the system is on, the initial
screen appears automatically. If the screen does not appear, use
the steps 1 and 2.
1
Press HOME MENU.
2
Select "Home Gallery" (/ then ENTER).
Folder selection
MEMORY_CARD
folder 1
folder 2
folder 3
folder 4
3
Select a folder (/ then ENTER).
ANALOG RGB
L AUDIO R
PC
1 / 1
10
51
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents