Pioneer KRP-500A Operating Instructions Manual page 17

Preparation
Media Receiver (rear)
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect the 75-ohm coaxial cable (commercially available) to
the ANT IN (antenna input) terminal.
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the Media Receiver.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.
Routing cables
Use the cable clamps as necessary to route the connecting cables.
The diagram below shows the location of the holes on the rear of
the display.
Display (rear)
Attaching and removing a cable clamp
Thread the clamp band through the holder [1] and bundle the
cable(s) in the cable clamp. Push and hold the levers then insert
the hook into an appropriate hole [2] on the rear of the display. Pull
up the clamp band to lock.
2
• Confirm that the cable clamp is seated firmly in the panel.
To remove the clamp band, pull and hold the latch to release.
1
Cable clamp
To remove the cable clamp, push and hold the levers then pull it out
from the hole.
Latch
Note
• Avoid pinching or creating pressure points when routing or
bundling cables.
• The longer a clamp is in place, the better chance of
deterioration. An older clamp is more easily damaged while
being removed and may not be reusable.
• Use the cable clamps as necessary.
• Be careful not to subject any connecting cables to strain.
Tidying the speaker cables
Use the supplied cable clamps as necessary to tidy the speaker
cables.
Display (rear)
Speaker cable
When the optional color sensor is attached:
Display (rear)
Cable guide (supplied with the color sensor)
Attach the cable guides here to bundle the
color sensor cable.
Cable clamp
Color sensor cable
Color sensor
Lever
Lever
Speaker cable
The groove at the bottom is
for speaker cables. Do not
insert the optional color
sensor cable in the groove.
Color sensor terminal
Speaker cable
05
17
En