Whirlpool SF367PEY Use And Care Manual page 24

Surface burners and cooktop
The cooktop and burner box areas are
specially designed to make cleaning easier.
Because the four burners are sealed,
cleanups are easy and convenient.
To clean the cooktop, wipe with a damp
sponge and dry.
NOTE: Do not remove the cooktop. Doing
so could result in product damage.
Cleaning the contoured well
areas
The contoured well is a recessed area
located around each burner.
if spills occur in contoured well section:
1. Blot up spill with a paper towel.
2. Wipe with a clean, damp sponge.
3.
Dry.
NOTE: When cleaning the cooktop area or
around the burner base, use care to prevent
damage to the ignitor. If a cleaning utensil
should catch it, the ignitor could be damaged
or broken. If the ignitor is damaged or
broken, the surface burner will not light.
When cleaning the cooktop, leave the burner
cap in place to protect the ignitor from
possible damage.
Cleaning the surface burners
l
The burner caps should be routinely
removed and cleaned. Always clean
burner caps after a spillover. Keeping the
burner caps clean prevents improper
ignition and an uneven flame.
l
For proper flow of gas and ignition of the
burner, DO NOT ALLOW SPILLS, FOOD,
CLEANING AGENTS, OR ANY OTHER
MATERIAL TO ENTER THE GAS TUBE
OPENING.
l
Gas must flow freely through the small
hole in the brass orifice for the burner to
light properly. This area must be free of
any soil and be kept protected from
boilovers or spillovers. ALWAYS keep the
burner caps in place whenever a surface
burner is in use.
24
, Burner cap
Contoured
well area
\
Gas tube
--
w
\ Burner pan
opening
Igniter'