Omron F160 Operation Manual page 302

Screen Display and Monitor
Image after Position Compensation
Note *The default setting is marked with an asterisk.
Display Image
The Display Settings Screen will be displayed.
Display settings
Display image
Display results
Compensated image
Scene/mode menu
Overall judgement
Processing time
↑ ↓
End
3. Change the settings for each item.
4. Select End.
The settings will be registered and the screen in (2.) will return.
Select the image display after measurement if position displacement compen-
sation has been specified.
If the Display Image Type setting is Through or Reduction Through, the setting
made here will be ignored.
Selection
Display* The image scrolled the position compensation amount will be dis-
played. Be careful, however, because the following restrictions
apply.
If the BUSY signal is set to remain ON until Display end, the mea-
surement time will be extended (by up to 16.7 ms.) Refer to
page 314.
If the BUSY signal is set to remain ON until Image input end or
Measurement end, the display may become disrupted if the
STEP input interval is short, because the next image will be read
before the image display has been completed. Refer to page 314.
Not display Displays an image that has not been scrolled, i.e., the image as
read by the Camera.
Select the type of itmage to be displayed in the background.
Selection
Freeze* A still of the image taken by the Camera is displayed. This image
is updated when measurement is performed.
Select Freeze when measuring moving objects.
Through The latest image taken by the Camera is displayed directly.
If measurement is performed using Through display, the mea-
surement time will be increased by the amount of time from when
the measurement command is input until the image input starts.
This delay is included in the measurement time shown on the
Monitor and Run Mode screens.
:
Freeze
:
None
:
ON
:
ON
:
ON
ON
Details
Details
Section 6-4
291