Backguard; Storage Drawer Removal; Storage Drawer Track Removal; Warming Drawer Removal - Maytag AER4311AAW Service Manual

Disassembly Procedures
!

Backguard

NOTE: Requires removal of oven from installation
position.
1. Remove maintop assembly, see "Maintop Assembly"
procedure.
2. Remove screws securing upper back panel form unit.
3. Remove screws securing bottom outside edges of the
backguard to unit chassis.
4. Reverse procedure to reinstall backguard.

Storage Drawer Removal

1. Pull drawer straight out to first stop. Lift the front and
pull out to second stop.
2. Let front of door rest on floor. Place hands toward
back of drawer and lift it out.
3. To replace:
a. Place the set of rollers on the drawer behind the
set of rollers on the oven. (As shown above.)
b. Align the guides and push the drawer back into
position.

Storage Drawer Track Removal

1. Remove the storage drawer by pulling it out to the
fully open or stop position, lifting the drawer at the
rear to disengage the drawer track rollers from the
drawer runners, and sliding the drawer out of the
range.
2. The tracks are mounted to a rear support and the
frame of the range. Remove the two track mounting
screws and remove the track. If the track support is
being replaced, remove the mounting screw securing
it to the side frame and remove the support.

Warming Drawer Removal

1. Pull warming drawer out as far as it will go.
2. Located on each side of the track is a plastic lever
inside the track location. Push the left side down and
the right side up to release slide from track and pull
forward.
3. When installing warming drawer, align slide with track
and push warming drawer into place.
20
WARNING
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.

Warming Drawer Element

1. Remove warming drawer, See "Warming Drawer
Removal" procedure.
2. Remove screws securing element to bottom and
back of chassis.
3. Pull element forward until element end are through
the back of the unit.
4. Disconnect wire terminal from element.
5. Reverse procedure to reinstall element.

Oven Light Assembly

Oven Light Bulb/Oven Light Socket
NOTE: Requires removal of unit from cabinet to replace
oven light socket.
1. Turn power off.
2. Open oven door to gain access to oven light.
3. Unscrew (counterclockwise) glass knurled dome.
4. Unscrew (counterclockwise) oven light bulb.
NOTE: Proceed with the following steps for oven light
socket removal.
5. Remove unit from installation position, see
"Removing and Replacing Oven" procedure.
6. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
7. Remove screws securing back cover and remove.
8. Carefully displace fiberglass insulation away from
rear of light socket.
9. Push inner assembly of light socket towards rear of
range, or twist out, depending on style of base.
10.Disconnect wires from light socket.
11. Reverse procedure to reinstall light socket.
Reposition insulation around lamp socket. Do not
overtighten.
NOTE: Reposition fiberglass insulation around oven
light socket to eliminate possibility of heat
related problems.
16023528 ©2004 Maytag Services