Production Mode - Kenwood DDX3021 Service Manual

[BACK] key: invalid
• The following screen is displayed when update information
(update successful) is received.
[BACK] key: invalid
4.2.7 STEERING REMOTE DEVELOPMENT screen
[BACK] key: Goes back to the SERVICE MODE
4.3

Production mode

4.3.1 Key operation when going into production mode
Press and hold the [FNC] key (1) and press the [RESET] key (2).
(2)
(1)
4.3.2 Display, operation setting, and special key operation
in production mode
4.3.2.1 Display in production mode
In order to allow the operator acknowledge that they are in the
production mode, "Production Mode" POPUP is constantly dis-
played.
<Display/Hide Conditions>
Display: GUI control screen, video screen <including Control,
Menu Control>
Hide: Setup screen, MODE screen, Test Mode screen <SS,
Service>
4.3.2.2 Initial setting in production mode
Volume initial value
Volume maximum value
FAN control
DISC module image output
SETUP > BEEP
SETUP > CAMERA INPUT
SETUP > Audio > Fad/Bal
SETUP > Audio > Vol Adjust
SETUP > Audio > HPF Front
SETUP > Audio > HPF Rear
SETUP > Audio > LPF
SETUP > Audio > SW Level
SETUP > Audio > SW Phase
SETUP > Audio > Loudness
SETUP > Audio > Equlizer
SETUP > Audio > Speaker Select
SETUP > Audio > Subwoofer
SETUP > INPUT > AV-INPUT
AV-OUT
*1: FAN is On at all times even during normal operation.
*2: Depends on the Back UP memory.
*3: Discards the Back UP memory and performs setting forcibly.
4.3.2.3 Special key operation in production mode only
(invalid in normal mode)
[TEL] key + [Touch panel upper right corner] (Press twice) Tran-
sit to SS mode.
4.3.2.4 Protection when production mode is continued
If the production mode continues for 30 minutes, the unit turns its
power OFF, and power ON is disabled until reset.
(No.WA022<Rev.001>)29/36
Production
Item
mode
→
33(-10dB)
Always ON
NTSC
OFF *3
ON *3
→
→
→
→
→
→
→
OFF
→
→
→
AV-IN
DVD
Normal mode
15(-34dB)
35(0dB)
ON/OFF *1
NTSC/PAL
ON *2
ON *2
CENTER
0 (all sources)
Through
Through
Through
0
Normal
ON
Natural
Standard
ON
AV-IN/iPod
(Depending on
the destination)
OFF