Kenwood DDX6039 Installation Manual
  1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Monitor
  5. DDX6039
  6. Installation manual
Kenwood DDX6039 Installation Manual

Kenwood DDX6039 Installation Manual

Monitor with dvd receiver
Hide thumbs Also See for DDX6039:

Advertisement

Table of Contents

See also: Service Manual , Instruction Manual
MONITOR WITH DVD RECEIVER
DDX6039

INSTALLATION MANUAL

© B54-4491-00/00 (MV/XV)

Advertisement

Table of Contents
loading

Related Manuals for Kenwood DDX6039

Summary of Contents for Kenwood DDX6039

  • Page 1: Installation Manual

    MONITOR WITH DVD RECEIVER DDX6039 INSTALLATION MANUAL © B54-4491-00/00 (MV/XV)
  • Page 2 Accessories ..1 ..1 ..1 ..6 ..2 ..6 ..1 ..1 English...

  • Page 3: Installation Procedure

    Installation Procedure 1. To prevent a short circuit, remove the key from the 2WARNING ignition and disconnect the - battery. • If you connect the ignition wire (red) and the 2. Make the proper input and output wire connections battery wire (yellow) to the car chassis (ground), for each unit.
  • Page 4 Connect to the terminal that is grounded when either Mute wire (Brown) switch the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Motor antenna control wire Depending on what antenna you are using,...

  • Page 5: Navigation System (Optional)

    Rear view Connection cable (Included in the Navigation system) Wiring harness (Accessory 1) Connection cable Navigation System (Included in the TV tuner) (Optional) REVERSE ILLUMI White/Black To front left speaker White MUTE Gray/Black To front right speaker Gray Green/Black. ANT. CONT To rear left speaker Green Purple/Black...

  • Page 6: System Connection

    System Connection Do not connect. Cooling fan To Navigation System ■ Rear View Camera Input • Visual input (Yellow) ■ Audio/Visual Output • Visual output (Yellow) ■ Audio/Visual input • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) ■...

  • Page 7: Installing The Escutcheon

    Installing the Escutcheon ■ For General Motors 1. Refer to the section <Removing the Hard Cut out to meet the shape of the Rubber Frame> and then remove the hard opening in the vehicle. rubber frame. 2. Cut out accessory 4 to meet the shape of the opening of the center console.
  • Page 8 Installing the Escutcheon ■ For Nissan 1. Refer to the section <Removing the Hard Rubber Frame> and then remove the hard rubber frame. 2. Attach accessory 6 to the unit. Accessory 6 English...
  • Page 9 Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Accessory 2 Self-tapping screw Metal mounting strap (commercially available) (commercially available) Make sure that the unit is installed securely in place.
  • Page 10 Installing in Japanese-Made Cars ■ Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 7 (M5x6mm) or Accessory 8 (M5x7mm) Car Bracket Accessory 7 (M5x6mm) or Accessory 8 (M5x7mm) English...

  • Page 11: Removing The Unit

    Removing Monitor/Player Unit ■ Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 3 Removal Tool (Accessory 3) and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure.

Table of Contents