Kenwood DDX3021 Service Manual page 20

3.2.7 Removing the Slide cam assembly (See Fig.13)
(1) Slide to backward the Slide cam assembly and the remove
the Slide cam spring.
(2) Slide to frontward the slide cam assembly, and then take
out it.
Slide cam assembly
3.2.8 Removing the Photo board (See Fig.14)
(1) Pressing the hook c and then slide to backward (slide to the
arrow side) the Disc plate.
(2) Remove the one screw F attaching the Photo board.
Photo board
3.2.9 Removing the Loading motor (See Fig.15 to 18)
(1) Remove the A wheel gear. (See Fig.15)
Slide cam spring
Fig.13
c
hook
c
hook
F
Fig.14
A Wheel gear
Fig.15
(No.WA022<Rev.001>)20/36
(2) Remove the A worm gear, M connect gear and M wheel
gear by sequentially. (See Fig.16)
A worm gear
M connect gear
M wheel gear
(3) Remove the two screws G attaching the Loading motor.
(Se Fig.17)
G
(4) When attaching the Loading motor, motor wire should arrange
to figure. (See Fig.18)
Wire arrangement
3.2.10 Removing the Roller assembly (See Fig.19)
(1) Remove the Slit washer.
(2) Remove the R middle gear.
(3) Remove the R connect gear.
(4) Snap off the part a of the Roller assembly.
(5) Lift up the part b of the Roller assembly, and then release
part c (When release part c, R collar R is easy to come off,
does not lose it).
CAUTION:
When reattach the Roller assembly, Middle gear should keep
direction and Slit washer should be change new part.
Fig.16
Fig.17
Fig.18