Check Chains; Lower Link Holder; Drawbar (If Equipped); Adjusting Drawbar Length - Kubota L47TL Operator's Manual

74 3-POINT HITCH & DRAWBAR
BCheck Chains
Remove the snap pin and adjust the turnbuckle to control
horizontal sway of the implement.
After adjustment, re-set snap pin.
(1) Turnbuckle
(2) Snap pin
BLower Link Holder
When operating the tractor without a 3-point hitch
implement, it is necessary to lock the lower links to
prevent them from hitting the tractor rear wheels.

DRAWBAR (if equipped)

To avoid personal injury or death:
A Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
BAdjusting Drawbar Length
When towing an implement, recommend use of (A) holes
in drawbar.
The drawbar load is
LIMITATIONS" section.
(1) PTO shaft Holes: (A)
(2) Drawbar
(3) Drawbar pin
referred to "IMPLEMENT