Toshiba e-STUDIO163 Service Handbook page 92

(6) After the adjustment for the code 411 is completed, apply the same adjustment value for the
code 410.
(Adjustment Mode)
(Key in the same value in the step 5 above)
Press [ENTER] or [INTERRUPT] (Stored in memory).
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[C] Reproduction ratio of secondary scanning direction (Fine adjustment of main motor rota-
tion speed (Copier/Printer))
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Press [1] [INTERRUPT]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from
standard drawer of the equipment.
(3) Check the grid pattern on the test chart printed out and measure the distance C from the 10th
line at the leading edge of the paper to the 30th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
(4) Check if the distance C is within 200±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance C again.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
[ENTER] or [INTERRUPT] (Stored in memory)
"100% A" is displayed
Press [1] [INTERRUPT]
* The larger the adjustment value is, the longer the distance C becomes (approx. 0.125 mm/
step).
e-STUDIO163/203 ADJUSTMENT
(Key in the code [410])
(Key in code [421])
(A grid pattern is printed out.)
3 - 8
[START]
(Adjustment mode)
[START]
December 2005 © TOSHIBA TEC