Toshiba e-STUDIO163 Service Handbook page 34

Classi-
Code
fication
305 Scanner Image location adjustment
of secondary scanning
direction
(scanner section)
306 Scanner Image location adjustment
of primary scanning direc-
tion
(scanner section)
340 Scanner Reproduction ratio adjust-
ment of secondary scan-
ning direction
(scanner section)
350 Scanner Shading posi-
tion adjust-
ment
351
354 ADF Adjustment of ADF paper
alignment
356 Scanner Automatic adjustment of
ADF sensor and EPROM
initialization
357 ADF Fine adjustment of ADF
transport speed
358 ADF ADF sideways deviation
adjustment
359 Scanner Carriage position adjust-
ment during scanning from
ADF
e-STUDIO163/203 ERROR CODE AND SELF-DIAGNOSTIC MODE
Adjustment mode (05)
Func-
Items
tion
ALL
ALL
ALL
Original ALL
glass
ADF ALL
ALL
ALL
ALL
ALL
ALL
2 - 16
Default
<Accept-
RAM
able
value>
128 M When the value
<92-164> increases by "1", the
image shifts by approx.
0.137 mm toward the
trailing edge of the
paper.
128 M When the value
<0-255> increases by "1", the
image shifts by approx.
0.0846 mm toward the
front side of the paper.
128 M When the value
<0-255> increases by "1", the
reproduction ratio in the
secondary scanning
direction (vertical to
paper feeding direction)
increases by approx.
0.223%.
128 M 0.064 mm/step
<118-
138>
128 M
<118-
138>
10 M When the value
<0-20> increases by "1", the
aligning amount
increases by approx.
0.5 mm.
- M
50 M When the value
<0-100> increases by "1", the
reproduction ratio of the
secondary scanning
direction when using the
ADF increases by
approx. 0.1%.
128 M When the value
<0-255> increases by "1", the
image of original fed
from the ADF shifts
toward the rear side of
paper by approx.
0.0846 mm.
128 M When the value
<0-255> increases by "1", the car-
riage position when
using the ADF shifts by
approx. 0.1 mm toward
the original feeding side.
Proce-
Contents
dure
1
1
1
1
1
1
6
1
1
1
December 2005 © TOSHIBA TEC