Paper Misfeeding - Toshiba e-STUDIO163 Service Handbook

5.1.2

Paper misfeeding

[E12] Bypass misfeeding
Open the transfer cover. Is there any paper in front of the registration sensor?
YES
NO
Is the registration sensor working?
(Perform the input check in the test mode: 03-[INTERRUPT]OFF/[9]/[6])
l NO
l
l
l
l
l
l
l
YES
Is the bypass feed clutch working? (Perform the output check in the test mode: 04-204)
Is the bypass paper sensor working?
(Perform the input check in the test mode: 03-[INTERRUPT]OFF/[1]/[4])
l NO
l
l
l
l
l
l
l
l
YES
Check the bypass transport, feed separation and pickup rollers. Replace them if they are
worn out.
e-STUDIO163/203 TROUBLESHOOTING
Remove the paper.
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN26 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the registration sensor.
6) Replace the MAIN board.
1) Check if the connector of the bypass feed clutch and bypass paper
sensor are disconnected.
2) Check if the connector CN26 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor pattern on the MAIN board is short circuited or
open circuited.
5) Replace the bypass feed clutch and bypass paper sensor.
6) Replace the MAIN board.
5 - 4
December 2005 © TOSHIBA TEC