Solving Problems - Electrolux DF80 Instruction Manual

6. Solving Problems

Customer Support
In case the refrigerator presents any malfunction, check for the possible causes and corrections.
Probable Causes/Corrections
If the refrigerator
fails to work )
If the Fridge is not
Cooling
(Insufficient
Refrigeration)
Food frozen in
the refrigerator
compartment
Alarm sounding
Leak in the water con-
tainer (only DFI80 and
DI80X).
Function indicator
messages
The ice is not automa-
tically made (models
DFI80/DI80X)
Control panel but-
tons are not accep-
ting commands.
Touching the buttons
sound signal is not
emitted. The alarm
does not go off. TUR-
BO FREEZING/"DRINK
EXPRESS"/ "GOUR-
MET EXPRESS"
20
• Plug is off the socket.
• Product connected to different tension outlet.
• Bad contact socket
• Lack of electrical Power, off switch or burned
fuse.
• Power outage or voltage oscillation.
• Inadequate setting of the temperature control
of the refrigerator compartment.
• Direct sunlight or other heat sources close to
the refrigerator.
• Hindered air ventilation.
• Power supply with different tension than the
product's.
• Excessive open door time.
• Inadequate setting of the temperature control
of the refrigerator compartment.
• Food items to close to air outlets.
• Food items to wet.
• Door open
• Power supply with different tension than the
product's.
• Turbo Freezing / Drink Express / Gourmet
Express / Ice Express.
• Water leaking from the reservoir.
• Failure of a refrigerator function
• There is no water in the water compartment.
• Button "Ice Maker" deactivated.
• Ice container is not in position.
• Control panel locked.
• Power outage or voltage oscillation.
• Connect the plug to the socket.
• Connect the product to the right tension.
• Correct the defect in the socket.
• Wait the Power to return, change the fuse or
turn on the switch.
• Remove the plug from the electric outlet for
5 minutes reconnecting it on sequence.
• Adjust the temperature correctly
• See "Installation – Choose Location".
• Unblock the air outlet of Multi-Flow.
• See Electric Installation (page.3).
• Open only for the necessary time.
• Set temperature control properly.
• Reposition food items.
• Dry them before keeping.
• Close both doors. In case you wish more
time with open door(s), select function SHO-
PPING.
• See Electric Installation (page.3).
• End of programmed function. Open the doors
or press the button flashing
• Adjust seals and water connections properly.
• Call the Technical Service.
• Refill the container with potable water.
• Activate button "Ice maker".
• Place the container in its original position.
• Unlock the control panel according to instruc-
tions on page 6. With the control panel locked
the dispenser will not release water.
• Remove the plug from the electric outlet for
5 minutes reconnecting it on sequence.