Automatic Ice Maker “Ice- Maker”; Lamp Replacement; Water Container Cleaning; Water Tubes Replacement (Dfi80/Di80X) - Electrolux DF80 Instruction Manual

3. Leave it in a clean water container for three hours.
4. Remove and leave the deodorizer at rest to dry for
2 hours and assemble it again.
5. The deodorizer should be changed after its third
cleaning.
6. It is recommended the use of a small screwdriver to
remove the part supporting the deodorizer.
Automatic Ice Maker "Ice- Maker"
(DFI80/DI80X)
The ice maker has a
stick (A) that checks if
there is ice formed in
the ice storage contai-
ner. When cleaning the
ice maker, this stick,
must not be forced at nay direction.
The ice maker is placed in the superior left area
of the freezer compartment.
IMPORTANT
Before using the automatic ice maker, it
is recommended to clean the water con-
tainer, according to item "Water Container
Cleaning".
It is also recommended the disposal of the
first ice cubes. This will assure the ice trays
and other parts in contact with the water
before turning to ice, are clean. Dispose at
least 30 ice cubes before using it.

Water Tubes Replacement (DFI80/DI80X)

Your fridge allows the replace-
ment of the water tubes from
time to time, in order to maintain
the water purity at all times. It is
recommended the annual repla-
cement of the tubes.

Lamp Replacement

To replace the lamp in your
fridge, proceed as follows:
1. Turn the fridge off, by unplug-
ging the electrical power cord
from the wall outlet.
2. Remove the shelves in front
of the light lid (luminary).
3. Pull the luminary simulta-
neously with both hands until
it is completely loose (A).
4. Replace the used lamp with
an equivalent one (same
dimensions, tension and
maximum Power of 25 W).
5. Reattach the luminary, first
attaching the pins of one of
A
plastic cover ends (B) and
then, push the other end (C)
against the fridge wall, until it
is locked in the original position.
6. Attach the electrical power cord to the wall outlet.
Water Container Cleaning (only for models
DFI80 and DI80X)
WARNING
Before removing the reservoir from the door,
completely empty it.
1. Release the water tube
of the water container (1)
2. Remove the fridge door
container, lifting and
pulling according to the
picture (2).
3. Release the lateral locks
carefully (3).
4. Remove the main contai-
ner cover (4).
5. Remove the inside contai-
ner and remove the refill
carefully – filter element
(5).
6. Clean up all the parts (ex-
cept the refill) with warm
water and mild soap,
wash with running water.
7. Do not forget to reattach
the rubber seal cover from
the main container.
A
A
C
B
B
17