Installation; Remove The Base From The Packing; Choose The Location; Electrical Installation - Electrolux DF80 Instruction Manual

2. Installation

Remove the base from the packing

With the help of other adults,
carefully recline the fridge to one
of the sides. With someone's
help, break the base with your
hands. Tilt the refrigerator to the
other side and remove the rest
of the base.
In the back part remove the adhe-
sive tapes and unlock both back
spacers. Leave it in horizontal
position.

Choose the Location

Install your refrigerator in a ventilated location
away from direct sunlight and heat sources (stove,
ovens, etc.) and flammable products.
Do not install your refrigerator unsheltered (open
to weather).
For the definite position of the refrigerator, respect
the minimum distances recommended:
- On top: 10 cm
- Side: 10 cm
- Behind: 10 cm
Check if the spaces left in
the front of the fridge and
in the right side (looking
at the front of the fridge)
are enough to allow com-
plete opening of the door
and crisper drawer.
Leveling
Set the leveling feet to
ensure perfect refrigerator
stability, preventing rocking
movement. Leave frontal
casters rolling freely.
In order to perform the leveling feet must be com-
pletely on the floor.
To better close the door, the product must be
slightly reclined to the back.
The proper functioning of the refrigerator shall
depend on its perfect leveling.
On top
Behind
Side
WARNING
Leveling must be performed with closed
doors.
Your refrigerator was developed to use the
leveling feet, which come with it.
Therefore, do not use other feet other than
the original. There are wheels on the upper
back part of your refrigerator to facilitate
movement.
During packaging removal, the feeding cable
will be loose. To avoid damages, attach it
with adhesive tape in the back of the fridge.
After unpacking and leveling, wait at least
two hours before connecting your refrigera-
tor to prevent malfunctioning.

Electrical Installation

Before turning your fridge on re-
move the transparent protective
wrapping plastic applied on the
control panel in the freezer door.
Before connecting your refrige-
rator, check if the voltage on the
socket where it will be plugged
is equal to the one indicated on
the label next to the plug (on the
power cable) or on the refrigera-
tor ID label.
Be careful not to leave the refrige-
rator over the power cable.
Connect the refrigerator to an
exclusive socket. Do not use
extensions or T-connectors.
For your safety, request an elec-
trician of your trust to check the
condition of the electrical power
system at the location it will be
plugged and for further infor-
mation, contact the Technical
Service.
The socket wires where your
refrigerator will be connected
should be of copper and have
a minimum section of 2.5 mm².
3