Advertisement
4.
Adjust the camera's position so that the lens module can flush align with the tempered
glass. Secure the camera using the screws and washers to the bottom of the housing.
5.
Connect 24V power source to the power input terminal. Connect power wires from the
DC 12V output to the camera. You may also connect the 24V power to drive an external
IRs.
Below is the distribution board drawing power from 24V AC/DC.
AE-23A, AE-23B, AE-23C, AE-23D
24V AC/DC OUT
24V AC/DC IN
Camera heater
I/O terminal block
Power LED
12V DC OUT
Connectors to the front IR
7
IR angle selector
Lens flush
w/ edge of
enclosure
Heater
Blower
Advertisement
