Screws: M6x12 SEMS x4 • Alignment sticker • Installation Guide Compatible VIVOTEK Cameras Fixed Dome series FD9167-HT-v2, FD9367-EHTV-v2, FD9365-EHTV-v2, FD9391-EHTV-v2 You may also refer to VIVOTEK's website for the list of supported models. Support for other models can be available through time.
Installation Mounting Hole Definitions 1. Determine a secure location for the recessed-mount bracket. 2. Drill or cut a 228mm hole (in diameter). The maximum thickness of the ceiling/board is 24mm. The ceiling should be able sustain at least a weight of 3.3kg. 228mm Up to 24mm...
Page 4
4. Detach the dome cover from the recessed mount. 5. Install camera to the recessed-mount bracket by driving screws.
Page 5
NOTE: 1. Connect and route cables before you secure the recessed-mount bracket to a ceiling. 2. For details on the cable connections with each camera, please refer to their Quick Installation Guide. Optional: You can tie up a tether line to the top of the bracket in case the bracket may fall during the installatioin.
Page 6
6. Connect cables to the camera. 6-1. Re-install the top cover of the camera. 7. Use a #2 Phillips screwdriver to loosen the clamping plates (see drawing below) and insert the recessed-mount bracket through the hole in the ceiling.
Page 7
8. Use a #2 Phillips screwdriver to move the clamping plates down so that the ceiling/ board is caught between the clamps and the flange on the other side of the ceiling. Clockwise Counter- clockwise 9. Adjust shooting angle and check for a satistory image over a web session. When you have a satisifactory live view, secure the dome cover from below by turning it counter- clockwise.