Advertisement
6.
Connect the DI/DO signal lines from the distribution board, if applied, to the camera's
terminal block.
The day/night mode DI connection enables the synchronization of IR light and the
automated day/night switching mechanism on the camera.
A sample connection diagram consisting of a housing with IR illuminators and the IP816A
camera is shown below. Please refer to your camera's documentation if your camera
comes with different pinouts.
Tank ctrl
Tank low water
GND
Tank w/ pump
See drawing on the right for the washer kit
control board pinouts.
AWG26
AWG20
DC12V
AC24V
AC/DC 24V IN
Draws power
from AC24V or PoE
95W enclosure
pin 1
1. Pump motor ON/OFF
11
2. GND
3. Water level detector Low/high
4. GND
pin 1
1. Water tank EN
2. Water low level
3. N/C
4. GND
Advertisement
