Operation; Start Up Procedure; Shutdown And Storage - Champion 30000 Owner's And Operator's Manual

Operation

Operation
NOTE
Your air compressor does not require any
assembly.

Start Up Procedure

1. Before plugging compressor into power
outlet, make sure motor switch is in the
OFF position.
2. Place air compressor on a flat, level
surface.
3. Drain moisture from the air tank by
slowly opening the air tank drain valve
by turning clockwise. Once all the
moisture has drained out, close the
fitting securely
4. Turn output port regulator knob to a
closed position (counterclockwise)
5. Attach air hose and accessories.
6. Before plugging compressor into power
outlet check to see all components,
hoses, accessories, are all in working
order.
7. Plug power cord directly into a properly
grounded power source of the correct
voltage
6
8. Turn the compressor ON by moving the
motor switch to the AUTO/ON position.
Allow the tank pressure to build. Once
the air pressure reaches the preset
pressure maximum it will automatically
shut off.
9. Adjust regulator knob on outlet port to
appropriate pressure for particular
accessory

Shutdown and Storage

1. Turn the switch to the OFF position
2. Unplug compressor from power source
3. Turn the outlet pressure regulator knob
fully counterclockwise to close airflow to
port. Check pressure gauge that it reads
0 PSI
4. Remove air hose and any accessories
5. Slowly open tank drain valve to release
moisture from tanks. Tilt tank to
remove all moisture. When all moisture
has been removed, close the fitting
securely.
6. Allow the compressor motor to cool
down
7. Wipe down and store in a clean, dry, and
non-freezing location
Rev 30000-20080208