Cleaning; Fittings And Replacement Parts - FLIR A310 ex User Manual

11.2 Cleaning

The enclosure can be cleaned with a cloth, brush, vacuum cleaner or other similar products. If it is
necessary to remove the protective grid to clean the viewing window, the device must first be
disconnected from the mains. The window can be cleaned with water or with isopropanol (provided
that this is permitted in the relevant area).
Hazard caused by missing safety devices
Before removing the protective grid, disconnect the device and any connected fiber optic units and
secure them against being switched on inadvertently.

12 Fittings and Replacement Parts

Reference
O-ring for enclosure cover
M4x6 enclosure index screw ISO 4027
M4x6 enclosure locking screw ISO 4026
M20x2 cable connection seal
M5x12 protective grid fastening screw DIN 6912
Sun canopy
Mounting rail
M5x8 screw for mounting rail
Drying agent
Assembly wrench for rear cover with SW32 connection
Accessory, air purge collar
Cable connections and connectors may only be replaced after consultation with and approval from
the manufacturer.
Use of Incorrect Accessories and Replacement Parts
Failure to use the correct accessories and replacement parts will render the manufacturer's liability
and warranty void. Use only original accessories and replacement parts from AT-Automation
Technology GmbH.
Operating Instructions IRCamSafeEX-AXC
Ex d Enclosure for Infrared Cameras 17 AT-Automation Technology GmbH
Order number
102141613-14
102141613-19
102141613-18
102141613-33
102141613-17
102141613-11
102141613-12
102141613-31
102141613-32
102141613-50
102141615-120