5
Product identification
5.1
Name plate
NOTICE
Products that are marked with this symbol may
not be disposed of through municipal garbage
collection points.
NOTICE
The ambient temperature range on the name plate (7) refers
only to the transmitter itself and not to the measuring
element used in the measuring inset.
1
p
o
n
m
l
k
0
9
8
7
6
5
Fig. 7:
HART name plate (example)
1 Manufacturer, country of manufacture and production year
2 Type designation 3 Connection plan 4 Ex marking (optional)
5 Temperature classes, explosion-proof design (optional)
6 Safety class explosion-proof design 7 Safety integrity level
(optional) 8 Observe product documentation 9 CE symbols (EU
conformity) and specified designations of the quality assurance
(optional) j Software version number k Hardware version number
l Sensor configuration m Supply voltage range, typical current
range, log n Serial number o Order number p Ordering number
10 OI/TTR200-EN Rev. B | TTR200
2
4
A10228
6
Transport and storage
6.1
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
6.2
Transporting the device
Observe the following instructions:
— Do not expose the device to humidity during transport.
Pack the device accordingly.
— Pack the device so that it is protected against vibrations
during transport, e.g., by using air-cushioned packaging.
6.3
Storing the device
Bear the following points in mind when storing devices:
— Store the device in its original packaging in a dry and
dust-free location.
— Observe the permitted ambient conditions for transport
and storage.
— Avoid storing the device in direct sunlight.
— In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in the
order confirmation of the supplier apply.
6.3.1
Ambient conditions
The ambient conditions for the transport and storage of the
device correspond to the ambient conditions for operation of
the device.
Adhere to the device data sheet!
6.4
Returning devices
For the return of devices, follow the instructions in the chapter
"Repair" on page 20.