Product Identification - ABB 6X1ED Instructions Manual

PRODUCT IDENTIFICATION

The instrument is identified by the data plates shown in
Figure 1.
The Nameplate (ref.A) provides information concerning the
code number, maximum process working pressure (PS) and
temperature (TS), range and span limits , power supply and
output signal. See also the "Operative Limits" section in the
following. This plate also shows the transmitter serial number.
Please refer to this number when making enquiries.
A dedicated label (ref. B) is welded as standard to the primary
unit, carrying specific details of the transducer (diaphragms
material, fill fluid, range limit and identification number).
Ref. A
Ref. D
Ref. C
Ref. D
Important - The instrument serial number must always be quoted when making enquiries.
- 2 -
A Safety Marking plate ( ref. C) is fitted when the transmitter is
required to comply with hazardous area regulations, e.g. flame-
proof or intrinsic safety protection. Additionally Tag plate (ref.
D) provides the customer tag number and calibrated range; this
is screwed on the housing and can be removed to be wired-on
by the supplied stainless steel wire.
The instrument may be used as a safety accessory (category
IV) as defined by the Pressure Equipment Directive 97/23/EC.
In this case, near the CE mark, there is the number of the
notified body (1130) that verified the compliance.
DIN TYPE
HOUSING
Fig. 1 - Product identification
Ref. A
Ref. B
DIAPHRAGM
MATERIAL
SERIAL
NUMBER
BARREL TYPE
HOUSING
Primary Unit
FILL
FLUID
URL