Table of Contents
Advertisement
SETTINGS MENU
>Reset
>Power Trigger
>Main In
>System Update
>Exit
WARNING: Do not select Rear if you do not have a rear mounted IR sensor. Otherwise, you could
be locked out of all IR command control. If this happens and you have previously connected an iOS
or Android app to AiOS, you can use the app to change this setting. If not, you must reset AiOS.
Reset AiOS?
>NO
YES
Power Trigger
>OFF
ON
Main In Loop
>OFF
ON
Check for Updates?
No Updates Available
NO
>YES
60 sec
>OK
to Always ON or set to
turn off after a preset
amount of time in the
Auto-Sensing mode.
When the illumination
is turned off, it will
automatically turn on
when your hand
approaches the front
panel. Hence "Auto-
Sensing."
This will Reset AiOS to
factory default settings.
AiOS has a trigger
output so it can turn on
an external amplifier
(as an example) when
AiOS is turned on. This
is only useful if AiOS is
connected to other
components that
include Power Trigger
inputs.
If AiOS is connected to
an external processor
that must route the
signal back through
AiOS' amplifier output,
then Main-In Loop
should be turned on.
Firmware updates are
automatically
downloaded and
installed when checked.
This can add new
features or
improvements to AiOS
functions and features.
Exit will back out of the
menu settings
24
Advertisement
Table of Contents
