Installing The Micro Sd Card - HIKVISION DS-6102HLI-T User Manual


The pictures below are for reference only.
Steps:
1. Remove the battery
Loosen the 4 set screws on the rear panel of the device
using a straight screwdriver, and then remove the back
cover and battery.
2. Install the SIM card
Carefully slide the SIM card into the SIM card socket until
the card locks into place. Make sure that the card's gold
contacts face into the device and that the upper-left angled
corner of the card is positioned correctly. The upper one is
Main Card Socket 1 and the lower one is Slave Card Socket
2.
For DS-6102HLI-SE, only one SIM card socket is supported.
3. Install the antenna
Install the 3G or 4G antenna at the top of the device if the
Slave Card Socket 2 is equipped with a 3G SIM card or the
4G SIM card is adopted.

2.3.3 Installing the Micro SD Card

The device supports 32G memory itself. And you can also extend its storage capacity using a micro secure digital (SD) card.
The SD card socket locates under the rear panel of the device.
Perform the following steps to install the micro SD card:
User Manual of Portable Video Recorder
15