Installing The Saw Blade - daltile 1048BRS Operating Manual

UNPACKING AND SETTING UP
Replacing the Cutting Blade
Make sure to disconnect the machine from
the power supply before fitting or replacing
the cutting blade or when doing any main-
tenance on the machine.
Block the sawing spindle with the 6 mm
●
Allen wrench.
Unscrew the 22 mm. hexagon nut with the
●
wrench and remove the saw flange.
(Attention: Left-handed screw threading)
Clean the saw flanges.
●
Fit the new cutting blade on the center
●
ring of the motor flange. (Check the
direction of rotation and make sure the
blade is well centered)
Mount saw flange and tighten with the
●
hexagon nut.
DALTOOL 1048BrS OPERATING MANUAL V02/2008R1 PAGE 13