Tile Saw Specific Warnings - daltile 1048BRS Operating Manual

This method of positioning the cord prevents
the travel of water along the power cord and
the possibility of the water coming in contact
with the receptacle. If the plug or electrical
outlet gets wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that
supplies power to the machine. Then unplug
and examine the machine for the presence of
water in the outlet.
It is important to use extension cords that
are only intended for outdoor use. These
extension cords are identified by a marking
"Acceptable for use with outdoor appliances;
store indoors while not in use".
It is important to only use extension cords
having an electrical rating not less than the
rating of the product.
It is important not to use damaged extension
cords. Examine the extension cords before
using it and replace it if it is damaged.
It is important to not abuse the extension cord
and do not yank on any cord to disconnect it
from the outlet.
It is important to keep the cord away from
heat and sharp edges.
It is important to disconnect the extension
cord from the outlet before disconnecting the
machine from the extension cord.
It is important not to use an extension cord
that is undersized. Using an undersized
extension cord can result in low voltage to
the motor thus resulting in a motor burnout
or premature failure.
PAGE 10 DALTOOL 1048BrS OPERATING MANUAL V02/2008R1
DALTOOL
®
SAFETY
To choose the proper extension cord;
Locate the length of extension cord
●
needed in the table below
Once the proper length is found, move
●
down the column to obtain the correct
AWG size required for that length of
extension cord.
Extension Cord Minimum Gage for Length
Volts Total Length of Cord [ft]
120V 25 50
AWG AWG
14 12
TILE SPECIFIC WARNINGS:
Always wear eye and hearing protection.
●
Always disconnect the saw before con-
●
ducting any type of service on the
machine, including when changing
cutting blades and cleaning.
Use the machine only with DALTOOL 10"
●
wet cutting blades.
Always replace damaged cutting blade
●
before operating.
100 150
AWG AWG
Not recommended