Installing The Saw Blade; Replacing The Cutting Blade - daltile 828 BrS Operating Manual

UNPACKING AND SETTING UP

Replacing the Cutting Blade

Make sure to disconnect the machine from the
power supply before fitting or replacing the cut-
ting blade or when doing any maintenance on
the machine.
Remove blade guard.
Block the sawing spindle with the 5 mm
Allen wrench.
Unscrew the 19 mm. hexagon nut with the
wrench and remove the saw flange.
(Attention: Left-handed screw threading)
Clean the saw flanges.
Fit the new cutting blade on the center ring
of the motor flange. (Check the direction of
rotation and make sure the blade is well
centered)
Mount saw flange and tighten with the
hexagon nut.
Place the blade guard and tighten with the
2 knobs.
DALTILE 828 BrS OPERATING MANUAL V02/2004R1 PAGE 13