Electrical Requirements And Grounding Instructions - daltile 1048BRS Operating Manual

ELECTRICAL REQUIREMENTS
AND GROUNDING
INSTRUCTIONS.
In order to prevent potential electrical shock
and injury, the following electrical safety
precautions and symbols should be followed
at all times!
In case of a malfunction or break-
down, grounding provides a path of
least resistance for electric current
to reduce the risk of electric shock.
This tool is equipped with an electric cord
having an equipment-grounding conductor
and a grounding plug. The plug must be
plugged into a matching outlet that is pro-
perly installed and grounded in accordance
with all local codes and ordinances.
Do not modify the plug provided – if it
●
will not fit the outlet; have the proper
outlet installed by a qualified electrician.
Improper connections of the equipment
●
grounding conductor can result in a risk
of electric shock. The equipment-
groun ding conductor is the insulated
conductor that has an outer surface that
is green with or without yellow stripes. If
repair or replacement of the electric
cord or plug is necessary, do not
connect the equipment-grounding con-
ductor to a live terminal.
Check with a qualified electrician or
●
service personnel if the grounding
instructions are not completely under-
stood, or if in doubt s to whether the tool
is properly grounded.
Use only 3-wire extension cords that
●
have 3-prong grounding plugs and
3-pole receptacles that accept the tool's
plug.
Repair or replace a damaged or worn
●
cord immediately.
DALTOOL
®
SAFETY
This tool is intended for use on a
circuit that has a 3 pole outlet.
To reduce the risk of electrocuta-
tion, keep all connections dry and
off the ground.
A Ground Fault Circuit Interrupter (GFCI)
should be provided on the circuit(s) or
outlet(s)to be used for the Saw. Receptacles
are available having built-in GFCI protections
and may be used for this measure of safety. A
GFCI is not supplied with the machine.
When using an extension cord, the GFCI
should be installed closest to the power
source, followed by the extension cord and
lastly, the saw.
Shock Hazard. For replacement, use only
an identical DALTOOL water pump, Item #
6.513.298
To avoid the possibility of the machi-
nes plug or electrical outlet getting
wet, position the saw to one side
of a wall mounted outlet. This will
prevent water from dripping onto the outlet
or plug. A "drip loop" should be arranged by
the user to properly position the power cord
relative to the power source. The "drip loop"
is that part of the cord below the level of the
outlet, or the connector, if an extension cord
is used.
Continued on page 10
DALTOOL 1048BrS OPERATING MANUAL V02/2008R1 PAGE 9