Unpacking And Setting Up; Unpacking And Assembly; Cooling System; Connecting To Power Supply - daltile 1048BRS Operating Manual

UNPACKING AND SETTING UP
Unpacking and Assembly
Unpack the tile saw and inspect
●
for any damaged parts.
Install the legs in the sockets at the
●
under side of the water container and
fasten with the knobs. Markings show
the right position.
Level the tile saw by adjusting the
●
legs in the sockets and make sure its
stable.
Release the transportation lock.
●
Setting the Cutting Depth:
By loosening the knob the saw head can
●
be positioned at the desired height.
The saw head is tightened by a spring
and may accidentally jump up when the
knob is loosened.
PAGE 12 DALTOOL 1048BrS OPERATING MANUAL V02/2008R1
Transportation Lock
Cooling System
Operating the water pump without a suf-
ficient supply of water may result in pump
damage.
Place the plug in the drain of the water
●
container.
Fill the container with water until the
●
water pump is completely submerged.
Connecting to Power Supply
Before connecting the machine make sure
that:
the line voltage corresponds with the
●
data on the machine's specifications
plate,
there is a grounded power supply,
●
the extension cord's meets criterea as
●
mentioned in the table on page 10.
Motor Protection
The motor is equiped with a thermal safety
switch for protection against an overload.
When the motor gets overheated, the switch
falls back into its initial position and can only
be switched on again after the motor has
cooled down.