Motor Protection; Installing The Saw Blade - daltile 1020 TS Operating Manual

UNPACKING AND SETTING UP

Motor protection

The motor is equipped with a thermal safety
switch for protection against an overload. When
the motor gets overheated, the switch falls back
into its initial position and can only be switched
on again after the motor is cooled down.

Installing the saw blade

Make sure to disconnect the machine from the
power supply before fitting or switching the cut-
ting blade or when doing any maintenance on
the machine.
Remove blade guard.
Block the sawing spindle with the 12 mm.
wrench.
Unscrew the 24 mm. hexagon nut with the
wrench and remove the saw flange.
Clean the saw flanges.
Fit the cutting blade on the center ring of
the spindle flange. (Check the direction of
rotation and make sure the blade is well
centered)
Mount saw flange and tighten with the
hexagon nut. Place blade guard and secu-
re it using the 2 knobs.
Adjustable cutting depth stop.
The adjustable stop is pre-set for a 10 inch
blade to prevent cutting into the Movable
Cutting Table.
When using smaller blades, the stop can
be adjusted to a cutting depth approxima-
tely 1/4 inch below the surface of the
Movable Cutting Table.
DALTILE 1020TS OPERATING MANUAL V02/2004R1 PAGE 13