Electrolux T4290 Installation Manual page 12

12
Setup T4650
Unpacking
When unpacking the machine, handle it with
care. There are no transportation brackets to
remove.
Fig. 1 From factory the dryer is equipped with
4 supporting feet A.
Remove the dryer from the pallet
At least two people are required to remove
the dryer from the pallet.
The tumble dryer is fastened to the pallet by 
transportation screws.
1. Open filter door. Remove the 2 transporta-
tion screws by the front.
2. Remove the bottom back plate. Remove
transportation screw by the back plate.
Mount back plate.
. Place a 1 1/2" steel pipe at the back of the
dryer as shown in fig. 2.
4. Stand behind the dryer and tilt it forward.
When the dryer rises from the pallet push
the pipe under the dryer, fig. .
. Push the dryer from the front so that it
hangs off of the back edge of the pallet,
fig. 4.
6. Remove the steel pipe by tilting the dryer
forward while removing the pipe.
. Install the 2 back feet (supplied the dryer).
8. Push the dryer backwards on the pallet
until it leans on the 2 back feet.
9. Mount the 2 front feet.
10. Remove the pallet.
11. The dryer is now on the floor.
If necessary, adjust the feet after the dryer is
in its final position. See next page.
Setup
1
2
M10

4
M10
A