Electrolux T4290 Installation Manual page 15

Continued
8. In order to prevent false air to enter, attatch
the sealing strip around the drum casing edge
on the same side as the door is to be hinged,
fig.  & 6 - see how it is done by looking at the
tape attatched on the opposite side.
Note! The sealing strip is enclosed in the
drum.
9. Make sure that the 4 guard strips on the
casing are intact before mounting the front
panel, fig. .
10. T4530/4650 only
Remove the small cover plate on the centre
front panel and mount it in the opposite corner.
11. Turn the front panel upside down and re-
mount it.
12. Turn the door upside down and re-mount it.
Test run
Check for proper operation of the door switch, as
follows:
1. Re-connect the power supply to the dryer
2. Attempt to start the dryer with the door open.
It must not start.
. Close the door and start the machine. Open
the door. The dryer must stop.
If the dryer starts with the door open, or fails to
stop when the door is opened during operation,
repair or replace the door switch, as necessary.
Door

6

1