Operating Your Espresso Machine Es 4010 - Catler 400 series Instructions For Use Manual

OPERATING YOUR ESPRESSO MACHINE ES 4010

Before using your Espresso Machine
- priming
To ensure that the boiler heating system and
all internal piping has been preheated, it is
essential to prime the machine before fi rst
use.
• Fill water tank with water to 'MAX'
marking line.
• Switch machine on and direct the steam
wand into the drip tray.
• Turn the steam dial on the side of the
machine towards the 'MAX' position
• Press button and hold down until
there is a solid stream of water exiting
from the wand. At this stage, release
button and turn the Steam Dial to the
'OFF' position.
• After approx 1.5-2 minutes all 3 buttons
will illuminate. Your Espresso Machine is
now primed and ready for use.
After steaming or when the water tank
runs dry, the Espresso Machine may not
pump water through the shower fi lter. If this
happens the boiler may require re-priming.
Please repeat the procedure as outlined
above.
Step 1 - Filling the water tank
• Remove the Filter Holder if locked into
the Brew Head and move the Steam
Wand to the side of the machine.
• Remove the water tank by pulling out of
the front of the machine (Fig 4).
• When the water tank is removed, a rigid
tube rotates and extends out of from the
water tank area. Do not touch or try to
remove this tube, it will automatically
slide back into place once the water tank
is reinserted.
• Fill with cold water to the maximum
mark and replace back into the machine,
pressing fi rmly so that the water tank
clicks into position.
4
The water tank should be fi lled with fresh cold
water before use. Check water level before use
and replace the water daily. Do not use mineral
water.
Step 2 - Preparing the coff ee
• Place the 1 or 2 cup fi lter into the fi lter
holder and fi ll with ground espresso
coff ee (Fig 5). Use the single fi lter for 1
cup and the double fi lter for 2 cups.
• Use the measuring/tamping spoon
provided to measure 1 level measure of
espresso coff ee for the single fi lter and 2
level measures for the double fi lter. It is
important to use the correct amount of
ground coff ee for each fi lter.
5
NOTE
OPERATING YOUR ESPRESSO MACHINE ES 4010
8