Bulk Provisioning - Cisco 7925G Installing Manual

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Bulk Provisioning

The Cisco Unified Wireless IP Phones support a Bulk Provisioning Utility. For more information, see the
Bulk Deployment Utility Guide at
792xBD.1-0-Readme.pdf.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G
Startup
After charging the battery and configuring the wireless IP phone, you are ready to power on the phone and
connect to the WLAN.
To power on the Cisco Unified Wireless IP Phone, press and hold the Power On button until the phone begins
its startup process by cycling through these steps:
1 The phone displays the Cisco Systems screen.
2 The phone screen displays these messages as the phone starts up:
3 The following information displays on the main phone screen:
When the phone passes through these stages with no errors, the phone has started up properly. Now the phone
is in standby mode and is ready to place or receive calls.
The signal icon in the upper left corner shows the strength of the signal between the wireless access point and
the phone. The phone must have an adequate signal to successfully place or receive calls. If the signal icon
displays only one bar, the weak signal can cause problems with phone performance.
Related Topics
Phone Startup Process, on page 18
Startup and Connectivity Problems
http://www.cisco.com/web/software/282074239/14006/
• Locating Network Services
• Configuring IP
• Network Up
• Configuring Unified CMList
• Registering
• Current time and date
• Primary directory number
• Main screen icons for four menus and Help
• Your current options on status line
• Softkey labels (Messages and Options)
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
Bulk Provisioning
17