Power Failure; Patient Information Center; Monitor Standby - Philips V24CT User's Reference Manual

Attaching the Patient
Power
If a power failure occurs, any alarm conditions that were stored in the
Failure
monitor will NOT be retained when power is restored. Settings such as
alarm limits stored in "T" modules ARE retained - see "Parameter
Settings Transfer" on page 3-61.
Caution
You are advised to check all the monitor settings after any power failure.
The monitor reacts according to the length of the power failure:
Less than 60 seconds
Less than 3 hours
More than 3 hours
Patient
If the monitor is connected to a Patient Information Center (78504 and
Information
78508) and you select the same lead for ECG channels 1 and 2, the wave
Center
is not displayed in channel 2 of the Patient Information Center.
Monitor
If you want to stop patient monitoring, but keep all settings and Patient
Standby
Data Management information, you can switch the monitor into

"Monitor Standby":

All waves and numerics disappear from the display, and all monitoring is
suspended. The word "Standby" appears in big letters on the screen.
2-10 Getting Started
1. Press
Alarms / Volume
2. Press
Monitor Standby
Pts
Refernce
Patient Data Management data and all
settings retained.
Patient Data Management data retained. All
settings revert to user defaults.
Patient Data Management data not retained.
All settings revert to user defaults. Time
setting may be lost if not networked.
or
Alarms
.