Operating Instructions - Flex L3403VRG Manual

Polisher L3403VRG
n Before using the machine, check that
the installed tools have been secured
according to the manufacturer's
instructions.
n Before using the machine, check that
the grinding tools have been installed
and secured correctly. Switch on the
machine at no load for 30 seconds!
Interrupt the test run immediately if
violent vibrations occur or other damage
is established. Check the machine to
determine the cause.
n Keep hands away from rotating tools.
n Do not load the polisher to such an
extent that it stops.
n Before putting the polisher down, switch
it off and wait until it stops.
n Protect persons and flammable objects
from flying sparks. Set the guard
correctly.
n Do not grind or cut materials which
release hazardous substances
(e.g. asbestos).
n If polishers are used outdoors or are
exposed to extreme metal dusts,
connect via a residual-current-operated
circuit-breaker (tripping current
maximum 30 mA).
n Use only extension cables permitted for
outdoor use.
n Mark the polisher with adhesive labels
only. Do not drill any holes into the
housing.
Damage to property!
n The mains voltage and the voltage
specifications on the rating plate (6)
must correspond.
n Do not press the spindle lock (4) until the
tool stops.

Operating instructions

Danger!
Before carrying out any work on the
polisher, always pull out the mains plug.
Before switching on the angle
grinder
Unpack the polisher and check that there
are no missing or damaged parts.
Attaching the bail handle
1. Push the bail handle over the gear
head, ensuring that the finger recess is
face down.
2. Attach the bail handle with the
2 enclosed screws and key (11).
Note
Alternatively, the handle (3) can be attached
(on the right or left). First, remove the bail
handle.
15