Power-On Options; Table 1-1 Power-On Options - Agilent Technologies u1273a User Manual

Power-on options

U1273A/U1273AX User's Guide
Some options can be selected only while you turn the
multimeter on. These power- on options are listed in the
table below. To select a power- on option, press and hold the
specified key while turning the rotary switch to any other
position (OFF to ON). Power- on options remain selected
until the multimeter is turned off.

Table 1-1 Power-on options

Key Description
Checks firmware version. The multimeter's firmware
version will be shown on the primary display. Press any key
to exit this mode.
Simulates the Auto Power-Off (APO) mode. Press any key
to turn the multimeter back on and resume normal
operation.
Displays the factory default power-on greeting. Press any
Dual
Exit
key to exit this mode.
Auto Power-Off (APO) is disabled until the multimeter is
turned off. To permanently disable APO, see
auto power-off (APO) timer"
Displays the user-defined power-on greeting. Press any
key to exit this mode.
Tests the OLED. All OLED pixels are lighted. Use this mode
to verify that there are no dead OLED pixels. Press any key
to exit this mode.
Smooth is enabled until the multimeter is turned off. To
permanently enable Smooth, see
mode"
Preparing Your Multimeter
on page 117.
on page 123.
Introduction
"Changing the
"Enabling smooth
13
1