Table of Contents
Advertisement
Battery Installation
WARNING: IMPROPER INSTALLATION OF THE TRANSMITTER BATTERIES CAN
CAUSE SERIOUS DAMAGE TO YOUR SYSTEM
Press down on the battery cover and slide in the direction of the arrow to
1.
remove.
2. Install 4 AA alkaline cells ensuring that the correct polarity (as marked in
the battery tray) is observed.
3. Refit the battery cover in reverse order.
CAUTION: ALWAYS BE RESPONSIBLE AND PROTECT THE ENVIRONMENT
WHEN DISPOSING OF BATTERIES. MOST LOCAL HOBBY DEALERS OR HOME
IMPROVEMENT CENTERS PROVIDE A FREE BATTERY DISPOSAL SERVICE.
Rechargeable NiMH
Loose AA size rechargeable NiMH batteries can be used and inserted into the
included battery holder. Be sure to follow the manufacturer's care and use
instructions.
WARNING: THE ET3 TRANSMITTER IS NOT COMPATIBLE WITH LIPO BATTERIES
CAUTION: LOOSE RECHARGEABLE BATTERIES MUST BE REMOVED FROM THE
TRANSMITTER AND BATTERY HOLDER FOR RECHARGING. CHARGING THEM IN
THE INCLUDED BATTERY HOLDER MAY CAUSE EXCESSIVE HEAT CAUSING DAMAGE
TO THE HOLDER OR EVEN MELTING OF PLASTIC.
Note: If the transmitter is not used for 1 week or more, it is highly recommended
to remove any batteries from the battery holder to prevent possible damage from
leaks and corrosion.
Receiver Installation & Connection
Installation
To achieve full operating range with your radio system it is critical that the
receiver antenna be installed properly and undamaged. It should be installed
with as much of the antenna as possible in a vertical position. The end of the
antenna should be contained inside an antenna tube. When installing:
8
2.4GHz Radio System
Hide quick links:
Advertisement
Table of Contents
