Firepower FP 125 Operating Manual & Installation Manual page 24

FIREPOWER FP 125,135,165
Pressure Adjust Device
Wire Spool Inlet Wire Guide
Figure 3-8: Wire Feeder Components
Route the Wire Through the Feedhead
1. Loosen Pressure Adjust Device (Fig. 3-9).
2. Open Pressure Adjust Device (Fig. 3-9).
3. Open Pressure Arm (Fig. 3-9).
4. Place the end of the wire into the Inlet Wire Guide,
feeding it over the Feedroll. Make certain that the proper groove
is being used (Fig. 3-10).
5. Pass the wire into the Gun Liner of the Gun Cable End
(Fig. 3-10).
6. Close the Pressure Arm (Fig. 3-10).
7. Close the Pressure Adjust Device. Tighten it to a "snug"
condition (Fig. 3-10).
8. Figure 3-11 shows the result with the wire installed.
NOTE!
If there is too much pressure on the drive
roll the wire gets locked and the motor
could get damaged, If it is too loose the
wire will not feed properly.
Pressure Adjust Device
Figure 3-9: Opening Pressure Arm
INSTALLATION
Pressure Arm
Gun Cable End
Art # A-09083
Feedroll
Pressure Arm
Art # A-09084
Pressure Adjust Device
Wire
Spool Wire Guide
Figure 3-10: Inserting Wire
Figure 3-11: Wire Installed
3-8
Pressure Arm
Gun Cable End
Art # A-09085
Feedroll
Art # A-09086
Manual 0-5123